OEMTOOLS 27090 Brake Anchor Pin Press, High-Grade Steel Truck Anchor Pin Press, 10 Ton Capacity Anchor Pin Bushing Tool, Anchor Pin Remover for Trucks, Green

Works great and a very very heavy duty tool.

Takes 1/2 drive input or 36mm socket to turn, removes most seized pins without heat. Severely sticks pins just need heat. Also has bushing adapter. Works very well

The extension snapped quickly, and the 1/2 driver hole is also ruined now, but at least you can get a 1 7/16 socket on it. Does the trick, nothing special. Somewhat annoying you need the centering bushing ring too

This product is built well. I did purchase LOCTITE LB 8034 High Performance Synthetic Grease to lube it up prior to first use and to clean and relube periodically. It works flawlessly! I have used pullers and presses over the last 28 years and I have spent/wasted more money on more expensive presses that are not built as tough. I have used this tool on over 50 anchor pins now and I mean the frozen anchor pins that are rusted it place. Let me tell you, this tool combined with the lube are the best combination I have found at this point. I only have minor thimble stress showing and 2 tiny irrelevant micro chips in the threads that happened on the very first use. I have been keeping a good eye on the threads just to leave an accurate review for the product. I highly recommend it.

I haven't had another anchor pin press to compare this to but it seems to be very well built. Frame is heavy and thread looks to be of high strength. Cranked this tool down until the screw stopped turning using an IR231 impact wrench, then hit the brake spider right where the pin is with a 3lb hammer like you are popping a tie rod or ball joint stud loose. The pin moved with a pop and the process is repeated until the pin is removed. The included adapter for removing the busing didn't seem to work so well for me but a separately purchased 29090 air hammer tool to remove and install bushings did the trick in just a few seconds.