EltakoFMS61NP-230V Power Push Switch

• Switchgear, power supplies and electronic electricity meters.
• For building installation and control technology.

Radio actuator, multifunctional surge switch, 230 V. 1+1 NO NO POWERFUL FREE 10A/250V AC BULBS 2000W Encrypted radio, bi-directional radio and repeater function can be switched on. Stand-by loss only 0.8 watts. For installation 45 mm long, 55 mm wide, 33 mm deep. Supply, sw and control voltage locally 230V. If the supply voltage fails, the sw state is retained. With recurring supply voltage is defined to be switched off. This wireless actuator as a multi-function electric shock switch has the most modern hybrid technology we develop: The wear-free reception and analysis electronics we have combined with two bistable relays that switch in the zero passage. This means that even when switched on, there is no coil loss and no heating through. After installation, wait for the automatic short synchronisation before the switched consumer is placed on the net. In addition to the radio control input via an internal antenna, this multi-function electric shock switch can also be controlled locally with a conventional 230 V control button installed in advance. In function 2xS only contact 1. Encrypted sensors can be learned from the manufacturing week 11/14. It can be turned on bi-directional radio and/or repeater function. Any change in condition as well as incoming central control telegrams are then confirmed with a wireless telegram. This wireless telegram can be learned into other actuators, GFVS software and universal displays. With the upper rotary switch, the LRN position assigns up to 35 radio buttons, one or more central control buttons. Then the desired function of this multi-function electric shock switch is selected. The switch is visualised by LED flashing. 2xS = 2-way surge switch with 1 N/O contact. 2S = 2 N/O Impulse Switch WS = shock switch with 1 N/O and 1 N/O contact. SS1 = Series switch 1 + 1 N/O with circuit sequence 1. SS2 = series switch 1 + 1 N/O with sequence 2. Lead sequence SS1: 0 - Contact 1 - Contact 2 - Contacts 1 + 2. Lead sequence SS2: 0 - Contact 1 - Contacts 1 + 2 - Contact 2. The lower rotary switch is only required for learning the transmitters. From the manufacturing week 08/2013, universal buttons and direction buttons can be learned. The LED accompanies the learning process according to the instruction manual and displays radio control commands by short flashing in operation.